Martin Yale 1217a Instrucciones de operaciones descargar pdf (Pagina 5)

Martin Yale Industries, Inc.

251 Wedcor Avenue

Wabash, IN 46992

SETTING THE FEED SYSTEM

NOTE: A continuous run can only be done with single sheets, or properly stapled

sets.

1. Lower the red wheel in the feed table until there is light between it and the black

one.

2. Turn unit on. Hold piece of stock to be ran in between wheels. Slowly raise red

wheel until sheet is pulled in.

3. Power down and set three pieces of stock to be tested in feed tray. Turn unit

back on, it should take them one at a time. If the sheets do not feed at all, the

red wheel is too high, if it tries to take more than one, the wheel is too low.

Readjust as necessary.

PROPER LOADING OF PAPER

To properly load the machine, the stack of paper should be put in the machine in a

reverse – fan. This means that the top sheet should be at the threshold of the black

wheel, and each sheet underneath should be a little further back. This will allow the

machine to pull off the top of the stack in a continuous fashion. It does not need to be

extreme. A ½” stack should be fanned out ½” from left to right (see photo).

Once the stock is placed into the machine, it will have a slight tendency to slide back

together. Do not attempt to prevent this, it should not be a factor. The paper guides

should not pinch the paper, there should be 1/32” clearance on each side.

Feed Roller

Threshold

Properly Fanned Paper

Retarder

abcoffice 800-658-8788 www.abcoffice.com

1 2 3 4 5 6 7 8 9

Sin comentarios

Martin Yale 1217a Instrucciones de operaciones Pagina 5